Panasonic VX400NTU Remote, control

Preparation

UsingRemoteRemotecon rolcontrol

Installing and Removing batteries

1111Open the cover	2222 Install batteries and close the cover
	(Insert the – side first.)

zzRemove the batteries in the reverse order of installation.

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector individually using single remote control, if unique ID number is assigned to each projector.

After setting the ID number of the projector, set the same ID number to the remote control. There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].

JJSetting the ID number

1)While holding down the <MENU> button, press the Number Buttons, the number you press the Number buttons corresponds to the desired ID code number.

2)The number you press the number buttons are as follows: Code 1= <1 MUTE>,

Code 2= <2 D.ZOOM +>, Code 3= <3 VIDEO>,

Code 4= <4 FREEZE>, Code 5= <5 D.ZOOM ->, Code 6= <6 S-VIDEO>.

3)The ID code is reset to [ALL] (default) by pressing the <MENU> button and <0 LAMP> button at the same time for 5 seconds or more.

Attention

zzThe status of the ID code is not stored after replacing batteries.

MENU button