Do not aim the camera at strong light sources.

A light source such as a spot light causes a blooming (light bleeding) or a smear (vertical lines).

Smear

Bright subject

Blooming

Installing place

Contact your dealer for assistance if you are unsure of an appropriate place in your partic- ular environment.

Make sure that the installation area is strong enough to hold the camera, such as a con- crete ceiling. When the installation area is not strong enough, reinforce and strengthen it.

Avoid installing in the following locations.

Locations where it may get wet from rain or water splash

Locations where a chemical agent is used such as a swimming pool (not only outdoor)

Locations subject to steam and oil smoke such as a kitchen

Locations near flammable gas or vapor

Locations where radiation or x-ray emis- sions are produced

Locations subject to strong magnetic field or radio waves

Locations where corrosive gas is pro- duced

Locations where it may be damaged by briny air such as seashores

Locations where the temperature is not within –10 °C - +50 °C {14 °F - 122 °F}.

Locations subject to vibrations (This product is not designed for on-vehicle use.)

Locations subject to condensation as the result of severe changes in temperature

Be sure to remove this apparatus if it is not in use.

Radio interference

When the camera is used near TV/radio antenna, strong electric field or magnetic field (near a motor or a transformer), images may be distorted and noise sound may be produced.

Mounting screws

It is necessary to procure screws or bolts to mount the camera. Prepare them according to the material and strength of the area where the camera is to be installed. The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area.

7

Page 7
Image 7
Panasonic WV-CP280, WV-CP284 Do not aim the camera at strong light sources, Installing place, Mounting screws