Panasonic WV-NW474S Light Control Setting ALC, To edit the Camera ID, Command Usage

To edit the CAMERA ID

1.Move the cursor to CAMERA ID. The factory default setting is OFF.

2.Press [SET]. The CAMERA ID menu appears. The cursor on the letter "0" is highlighted.

3.Move the cursor to the character you want to edit by pressing [Left]/[Right]/[Up]/[Down].

4.After selecting the character, press [SET]. The selected character appears in the editing area. (The cursor in the editing area moves to the right auto- matically at this moment.)

5.Repeat the steps above until all characters are edit- ed.

Command Usage

Move the cursor to the respective commands, and press [SET].

SPACE: Adds a blank space to the cursor position in the editing area.

POSI: Opens the camera ID position window. Move the highlighted camera ID to the desired position with [Left]/[Right]/[Up]/ [Down], and press [SET].

Highlighted

WV-NW474

Note: The camera ID will be displayed under the clock display when both of them are set to ON.

RET: Returns to the CAM SETUP menu.

END: Closes the setup menu and returns to camera image screen.

RESET: Cancels all characters in the editing area.

To replace a specific character in the CAMERA ID

1.Move the cursor to the editing area by pressing [Down].

2.Move the cursor to the character to be replaced by pressing [Left] or [Right]. Then move the cursor to the character area and select a new character.

3.Press [SET] to determine the CAMERA ID.

2. Light Control Setting (ALC)

2-1. ALC Mode with SUPER-D2 ON

Super Dynamic2 Function (SUPER-D2)

The important object in a scene is usually placed in the center of the monitor screen. In the SUPER-D2 mode, more photometric weight is given to the center of the screen (where the important object is located) than to the edge of the screen (where bright backlight would most likely be located). You can use the SUPER-D2 function if you select ALC. It eliminates interference by strong background lighting which makes the camera picture dark, such as a spotlight.

1.Move the cursor to ALC, and press [SET]. The ALC CONT menu appears.

2.Move the cursor to SUPER-D2 and select ON.

** ALC CONT **

BACK LIGHT COMP

SUPER-D2	ON
LEVEL	...I
	-	+

RET END

3.If you want to adjust the video output level, move the "I" cursor for LEVEL. Adjust to the desired level by pressing [Left] or [Right].

2-2. ALC Mode with SUPER-D2 OFF

1.Move the cursor to SUPER-D2 and select OFF. The MASK SET appears on the menu.

** ALC CONT **

BACK LIGHT COMP

SUPER-D2		OFF
MASK SET	↵
LEVEL		...I
	-		+

RET END

2.Move the cursor to MASK SET and press [SET]. The 48 mask areas appear on the monitor screen. The cursor is blinking in the upper left corner of the

screen.

Blinking

-24-