OPERATING PROCEDURES
Refer to
COMPATIBILITY
WX-CC2010 and WX-C1020
When PAGE is pressed during the TALK LOCK function is activated, the TALK LOCK function is canceled and PAGE sound comes out of the menu board.
TROUBLESHOOTING
Problem | Check item |
|
|
The communication between the order taker units and menu | • Is the POWER switch on the center module turned on? |
board cannot be established. (The TRANSCEIVER MONITOR | (Refer to p. 10.) |
indicator is not blinking in red.) | • Check the AC power outlet. |
| • Push the CIRCUIT PROTECTOR button. (Refer to p. 10.) |
| • Refer to the dealer or qualified service personnel. |
|
|
The communication between the order taker units and menu | • Is the CH SELECT switch set to 1 to 8? |
board cannot be established. (The TRANSCEIVER MONITOR | • If the problem remains even after trying the above, refer to |
indicator is blinking in red.) | the dealer or service personnel. (Refer to p. 10.) |
|
|
Cannot communicate with the customer at the menu board | • Check to see if the VEHICLE PRESENT indicator of the cen- |
(TALK), though the communication among personnel is O.K | ter module lights up when a vehicle drives up the speaker |
(PAGE is OK). | post or menu board. |
| • If the indicator does not light up, check the following. |
| 1. Is the vehicle detector plugged in? |
| 2. Check the AC outlet and fuse of the vehicle detector. |
| If the power and fuse are normal, refer to the qualified ser- |
| vice personnel. |
|
|
A menuboard speaker is always live, even when there is no | • Reset the vehicle detector. If the problem still remains, |
car beside the menu board. | remove and reinstall the fuse from the detector. (Refer to the |
| operating instructions of the vehicle detector.) |
| • If the problem remains even after trying the above, refer to |
| the dealer or service personnel. |
|
|
TALK (Talk PTT or Talk Lock mode) or PAGE (Page PTT or | • Confirm that there is no metal obstruction blocking around |
Page Lock mode) is unavailable in certain areas. | the center module. |
| • It may be necessary to extend the antenna to areas where |
| the reception is error. (Refer to qualified service personnel |
| or system installers.) |
|
|
STANDARD ACCESSORIES
Antenna | 1pc. |
Miniature Screwdriver | 1pc. |
Memo Label | 1pc. |
13