Power on the PhotoLink Scanner
1.Press the Power button. The power indicator light blinks.
Note: For more information on the indicator lights, refer to “Indicator Lights” on page 9.
2.Wait until the power indicator stops blinking and then goes off. The Status/ card indicator will light up, indicating that the scanner is ready.
Note: Do not insert an original photo into the feeding slot when the power indicator is blinking. The original photo will not be scanned.
Scan a Photo
1.Insert your photo into one of the plastic protection sleeves (included with scanner.)
2.With the side to be scanned facing upward and in correct orientation as indicated by the orientation guide, place one edge of the photo on the scanner and adjust the guide lever so that the photo aligns against the left side of the feeding slot.
3.Insert the photo into the feeding slot.
WARNING: Do not scan glossy photos in humid environments (humidity higher than 70% RH); the surface of the photo will become sticky and cause the scanner to jam.
11
