Pantech P2000 manual Alert message

Models: P2000

1 88
Download 88 pages 11.91 Kb
Page 79
Image 79

Alert message

If you experience any problem while using your mobile phone, please refer to the following checklist. If the problem still persists, contact your dealer or nearest carrier.

When the “Insert SIM Card” message appears:

Make sure the SIM card is correctly installed. Check to see if the SIM card is working properly. If it does not work, try to clean the contact points of the card with a dry cloth. If it is out of order, take it to your service provider.

When the “Messages full” message appears: The received or saved messages are full in your phone memory. You need to delete the message.

When the “Phone and SIM messages is full. Delete Messages” message appears:

The received or saved messages are full in your phone and SIM card memory. You need to delete the message.

When the “Password” message appears in Phone locked state:

Enter the phone password. The default password is”1234”. If you cannot remember the password, contact the nearest carrier.

When the “Enter PIN1” message appears:

Input PIN1. If you cannot remember it, contact your service provider. You can still receive calls even if your mobile phone becomes locked after entering the incorrect PIN1 on three consecutive attempts.

When the “No Service” or “Network Search” appears:

If you cannot make/receive a call when you are indoors or undergrounds where the signal strength is poor, move toward a window or go out to an open area. If you still cannot make a connection, contact your service provider.

Troubleshooting checklist

When audio quality is poor:

End a call and try again.

When the other party cannot hear you speaking:

Your phone may be set to MUTE. Disable the MUTE function. Or your hand may be covering the microphone located below the #key.

Appendix

When battery lifetime is shorter than usual:

 

01

This may happen when you are in an area

02

with low signal strength. Turn off your phone

03

when it is not in use. Change the battery when

04

battery energy is exhausted.

05

When your mobile phone does not turn on:

06

Make sure your battery is charged. Check to

01

see if your phone works while recharging the

 

02

battery.

03

When you are unable to send a message:

04

Either you are not registered to receive an SMS

 

05

service, or you may be in an area where your

06

network service provider cannot provide such

a service.

07

When you are unable to make a call:

Your phone may be set to“Fixed Dialing

157

Page 79
Image 79
Pantech P2000 manual Alert message