SNMP MIB Objects
E-15
3162-A2-GB20-30 March 1999
Near End Group – “dsx1Fdl” Object (dsx1ConfigEntry 13)
This object specifies how Facility Data Link is being used. Only the following
values are supported by the DSU/CSU. More than one value may be active at a
time.
dsx1other(1) – SNMP data is being sent over FDL.
dsx1Ansi-T1-403(2) – ANSI PRMs are supported on the network interface as
specified by ANSI T1.403.
dsx1Att-54016(4) – FDL supports the requirements specified by AT&T
publication TR54016.
dsx1Fdl-none(8) – Indicates that the device does not use FDL. This is the
only value that applies to the DTE Drop/Insert (DSX-1) interface.
Near End Group – The DS1 Current Table Objects (dsx1CurrentEntry)
The following DS1 current table objects are provided for the network interface
only. Objects in the table that are not listed are not supported and will return an
error status if access is attempted.
dsx1CurrentIndex – The index that identifies the T1 interface.
dsx1CurrentESs – Errored Seconds for the current interval.
dsx1Current SESs – Severely Errored Seconds for the current interval.
dsx1CurrentUASs – Unavailable Seconds for the current interval.
dsx1CurrentCSSs – Controlled Slip Seconds for the current interval.
dsx1CurrentBESs – Bursty Errored Seconds for the current interval.
Near End Group – The DS1 Interval Table Objects (dsx1IntervalEntry)
The following DS1 interval table objects are provided for the network interface
only. Objects in the table that are not listed are not supported and will return an
error status if access is attempted.
dsx1IntervalIndex – The index that identifies the T1 interface.
dsx1IntervalNumber – The interval number (1 to 96).
dsx1IntervalESs – Errored Seconds for the interval.
dsx1Interval SESs – Severely Errored Seconds for the interval.
dsx1IntervalUASs – Unavailable Seconds for the interval.
dsx1IntervalCSSs – Controlled Slip Seconds for the interval.
dsx1Interval BESs – Bursty Errored Seconds for the interval.