F-1

3162-A2-GB20-30 March 1999
IP Network Addressing Scenario F
Overview
This appendix describes a means of configuring 31xx Series devices in an
Internet Protocol (IP) network to provide SNMP or Telnet connectivity. Since there
are many possible network addressing schemes, this appendix describes an
addressing scheme for a typical customer network management system (NMS)
scenario. This appendix is not intended to be an IP addressing or routing tutorial,
and a basic understanding of IP and 31xx Series devices is assumed.

IP Network Addressing

The IP network addressing scenario (Figure F-1) consists of a series of 31xx
Series devices daisy chained together, with remotes connected via the FDL. In
this scenario, all 31xx Series devices are on the same subnet (135.18.1.0). The
subnet mask for each device is FF.FF.FF.00. A static route is set in the NMS host
to subnet 135.18.1.0.
The following notes apply to this scenario:
Connections to remote devices may be via EDL or FDL; however, the FDL is
only available on full T1 links (not fractional T1s). Check with the service
provider to be sure that the FDL is end-to-end (i.e., not terminated at an
intermediate point within the network).
Interconnected 31xx Series devices automatically pass routing information
between them; however, a static route to the subnet(s) must be set in the
routing table of the NMS host. This route uses the 31xx Series device
connected to the LAN (via the LAN Adapter), or the NMS (via a direct PPP or
SLIP connection) as a gateway to the subnet(s). In all instances, the
addressing scheme presented works for both the LAN and the direct
connections.
Although routing table entries are maintained automatically by 31xx Series
devices, without the need for user configuration, only a maximum of 100
routes is supported for a given device.
The choice of a host address within a given subnet is completely arbitrary.
Choose any legal host address for a given subnet, without regard to the local
or remote devices.