Operation
3-16 3162-A2-GB20-30
March 1999
Configuring the DSU/CSU for SNMP or TelnetAccess
To configure the DSU/CSU for SNMP or Telnet access,
Enable the SNMP agent or Telnet server within the DSU/CSU (see
Appendix C,
Configuration Options
).
Select and configure the port that provides the link to the SNMP or Telnet
system.
Set the Internet Protocol (IP) address and subnet mask needed to access the
DSU/CSU (see Appendix F,
IP Network Addressing Scenario
).
Select the link layer protocol (PPP or SLIP) for the port that provides the link
to the SNMP or Telnet system.
For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device’s Management Information Base (MIB)
(see Appendix C,
Configuration Options
).
For SNMP links, configure the device to send traps to the SNMP manager, if
desired (see Appendix C,
Configuration Options
,
and
SNMP Traps
in
Chapter 4,
Maintenance
).
Specify the Telnet password or SNMP validation options, if desired (see
Appendix C,
Configuration Options
).
Configuration Examples
NOTE:
The following procedures are examples only. This chapter uses examples to
help you become familiar with the use of the asynchronous terminal for
DSU/CSU control.