Paradyne 7975 manual Device Messages 1 What Message Indicates What To Do

Messages and Troubleshooting

Device Messages

The Device Messages in Table 6-1,listed in alphabetical order, can appear in the messages area at the bottom of the ATI screens.

Table 6-1. Device Messages (1 of 2)

Device Message	What Message Indicates	What To Do
Access level is	The operator requested that	If configuration options are to be
Operator.	configuration options be	edited, use a Login ID that has
Configuration is	loaded, but does not have	Administrator authority.
read-only.	authority to edit them.
Cannot Save ± no	All of the login IDs being	Change the access level of at
Login IDs with Access	saved have an access level	least one Login ID to
Administrator	below Administrator.	Administrator so that
		configuration changes can be
		made. (Operator-level users
		cannot make configuration
		changes.) Save the Login IDs.
Command Complete	Action requested has	No action needed.
	successfully completed.
Invalid Character ( x )	A nonprintable ASCII	Reenter information using valid
	character (x) has been	characters.
	entered.
Invalid ± Data	Network-initiated loopback	No action needed.
Terminal Initiated	was in progress when
Loopback Active	another selection was
	made.
Invalid Password	Login is required and an	H Try again.
	incorrect password was	H Contact your system
	entered; access is denied.
		administrator to verify your
		password.
Invalid ± Send Pattern	A pattern test was already	H Allow test to continue.
Already Active	in progress when the Start	H Select another test.
	field was selected.
		H Stop the test.
Invalid ± [Test]	The described test was	H Allow test to continue.
Already Active	already in progress when	H Select another test.
	another selection was
	made.	H Stop the test.
Invalid Test	A loopback or pattern test	H Wait until other test ends and
Combination	was in progress when Start	message clears.
	was selected to start	H Abort all tests from the Test
	another test, or was active
		menu screen.
	on the same or another
	interface when Start was	H Stop the test from the same
	selected.	screen the test was started
		from.

7975-A2-GB20-40 December 1998 6-3