Paradyne 7975 manual Table A-4. Communication Port 2

Configuration Option Tables

Table A-4. Communication Port (2 of 3)

Stop Bits

Possible Settings: 1, 1.5, 2

Default Setting: 1

Specifies the number of stop bits for the communication port.

1 ± One stop bit.

1.5± One and one half stop bits. 2 ± Two stop bits used.

Ignore Control Leads

Possible Settings: Disable, DTR

Default Setting: Disable

Specifies whether DTR is used.

Disable ± Control leads are treated as standard.

DTR ± DTR is ignored.

Login Required

Possible Settings: Enable, Disable

Default Setting: Disable

Specifies if an ID and password are required to access the asynchronous terminal interface on the communication port. Login IDs are created with a password and access level. Refer to Chapter 7, Creating a Login.

Enable ± Login ID and password are required to access the asynchronous terminal interface.

Disable ± No Login ID and password are required to access the asynchronous terminal interface.

Port Access Level

Possible Settings: Administrator, Operator

Default Setting: Administrator

Specifies the highest level of access allowed when accessing an ATI session through a Telnet session.

Administrator ± This is the higher access level, permitting full control of the 7975 Termination Unit. Access level is determined by the Login ID. If Telnet Login Required is disabled, the session access level is Administrator.

Operator ± This is the lower access level, permitting read-only access to status and configuration screens.

Inactivity Timeout

Possible Settings: Enable, Disable

Default Setting: Disable

Provides automatic logoff of a Telnet session.

Enable ± The Telnet session terminates automatically after the Disconnect Time.

Disable ± A Telnet session will not be closed due to inactivity.

7975-A2-GB20-40 December 1998 A-9