Parkinson Cowan U02059 S H E R A T O N, Fitting The Battery, Pressure Testing

Models: U02059

1 40
Download 40 pages 3.29 Kb
Page 37
Image 37
5. FITTING THE BATTERY

S H E R A T O N

be installed with an appliance flexible connection only. Supply piping should not be less than R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand

side of the appliance. NOTE: ONLY LIQUID SEALANTS

TO BE USED WHEN INLET GAS PIPE IS FITTED TO RESET VALVE I.E.: DO NOT USE P.T.F.E. SEALANT TAPE.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3. Take into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

250

400

Fig.3

650

5. FITTING THE BATTERY

1. The battery is located on the left hand side of the front plinth and can be viewed through a slot in the bottom left hand corner of the front frame( Fig 4.)

2.To gain access to the battery, pull the appliance forward, raise and support the front by a few (2-3) centimetres).

3.Fit the battery AA size ensuring the positive + terminal is on the right hand side as shown in the diagram. The battery may be pushed out of the holder by using a blunt implement, such as a spoon handle through the slot in the front frame if necessary.

4.Lower the appliance and push it back into place.

Fig.4

6. PRESSURE TESTING

1 The oven injector is used as a pressure test point.

37

Page 37
Image 37
Parkinson Cowan U02059 installation instructions S H E R A T O N, Fitting The Battery, Pressure Testing