Parkinson Cowan U02059 Installation, S H E R A T O N, Parts Required, Levelling The Appliance

Models: U02059

1 40
Download 40 pages 3.29 Kb
Page 35
Image 35
INSTALLATION

S H E R A T O N

INSTALLATION

1. PARTS REQUIRED

The loose hotplate parts and battery are packed in the polystyrene fitment on top of the hotplate.

2. LEVELLING THE APPLIANCE

If the appliance requires levelling or its height adjusting (from the hotplate to any working surface), the procedure below must be followed:

1.Loosen the lock nuts securing the rear wheels, using a 13mm spanner. Access to these lock nuts can be gained through a slot in the rear of the plinth, as shown in Fig.1c.

2.Adjustment to suit floor conditions or height is obtained by rotating clockwise or anticlockwise the hexagonal feet/wheels, at the front and rear of the appliance.

NOTE: The rear wheels must only be rotated through half or whole turns.

3.A spirit level should be placed on one of the oven shelves to confirm the appliance is correctly levelled.

4.Once the appliance is at the correct height and levelled, the rear wheel should be locked into position by means of the lock nuts, having first made sure the wheels are once again parallel to the side of the appliance.

Fig. 1c

Rear of

Appliance

Plinth

Lock Nut

Rear Wheel

3.FITTING THE STABILITY BRACKET

35

Page 35
Image 35
Parkinson Cowan U02059 installation instructions Installation, S H E R A T O N, Parts Required, Levelling The Appliance