Patton electronic 1004S Switch Settings, Switch Summary Table, Configuration Switch Applications

3.2.1 SWITCH SETTINGS

All possible settings for the Model 1004’s configuration switches are presented in the summary table below. If you have additional questions, contact Technical Support at (301) 975-1000.

SWITCH SUMMARY TABLE

Position	Function	Off Position	On Position
SW1-1	RTS/CTS Delay	0mS	8mS
SW1-2	Echo Enable	Echo “Off”	Echo “On”
SW1-3	Carrier Control	Constantly “On”	Controlled by RTS
SW1-4	Impedance	High (120K Ohm)	Low (120 Ohm)
SW2	2 wire/4 wire	2-wire	4-wire

SW 1-1: RTS/CTS Delay

The setting for Switch SW1-1 determines the amount of delay between the time the Model 1004 “sees” RTS and when it sends CTS. (This option is available in DCE mode only).

SW1-1	Setting
Off	0mS
On	8mS

SW 1-2: Echo Enable

Switch SW1-2 determines whether the Model 1004 echoes data back to the transmitting device. (Half duplex modes only).

SW1-2	Setting
Off	Echo Off
On	Echo On

SW 1-3: Carrier Control Method

Switch SW1-3 determines whether the carrier is “constantly on” or “controlled by RTS”. This setting allows for operation in switched carri- er, multipoint and/or hardware handshaking applications.

SW1-3	Setting
Off	Constantly “on”
On	Controlled by RTS
	5

SW 1-4: Impedance

Switch SW1-4 defines a termination resistance. The Model 1004’s generator can drive 50 unit loads including two termination resistances of 120 Ohms each.

SW1-4	Setting
Off	High (120K Ohm)
On	Low (120 Ohm)

SW 2: 2-Wire/4-Wire

Switch SW1-4 determines whether the Model 1004 will operate in either 2-wire or 4-wire mode.

SW1-4	Setting
Off	2-wire
On	4-wire

3.2.2 CONFIGURATION SWITCH APPLICATIONS

The table below shows you how to set the Model 1004's configu- ration switches to fit several common applications. If you have any questions, call Patton Technical Support at (301) 975-1007.

TYPICAL SWITCH APPLICATIONS

Switch		Point-to-Point		Multi-point
Settings
	4W	4W HDX	2W	4W	2W
SW1-1: RTS/CTS*	ON	ON	ON	ON	ON
SW1-2: Echo	OFF	ON	OFF	ON	OFF
SW1-3: Carrier	OFF	ON	ON	Master-OFF	ON
				Slaves-ON
SW1-4: Impedance	ON	ON	ON	Master - ON
				Slaves - HIGH
				Last Slave - ON
SW2: 2-wire/4-wire	ON	ON	OFF	ON	OFF

*NOTE: RTS/CTS Delay setting should be based upon transmission timing.

6