Patton electronic 1018RC 1 2 3 4 5 6 7, Features, Description, Function Card Configuration

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions arise during installation or use of the unit, contact Patton Electronics Technical Support: (301) 975-1007.

2.1FEATURES

•Switch-selectable carrier control

•Asynchronous operation

•Selectable data rates from 1200 to 57,600 bps

•Distances to 2.4 miles

•Point-to-point operation

•V.54 loopback tests and V.52 compliant BER tests

•Six easy-to-read LED indicators

•Transformer isolation

•Silicon Avalanche Diode surge protection

•Switchable 120V or 240V power supply

•Mounts in Patton’s 16-card rack chassis

2.2DESCRIPTION

3.0 CONFIGURATION

This section describes the location and orientation of the Model 1018RC’s configuration switches and jumpers, and provides detailed instructions for all possible settings.

The Model 1018RC uses a combination of DIP switches and jumpers that allow configuration to an extremely wide range of applications. Designed around a mid-plane architecture, the Model 1018RC incorporates both front and rear cards. Configuration of both may be necessary. The switches/jumpers are accessible when the cards are slid out of the rack chassis. Once configured, the Model 1018RC is designed to operate transparently, without need for frequent re-configuration: just set it and forget it!

3.1 FUNCTION CARD CONFIGURATION

The Model 1018RC front card has two sets of eight switches (S1 & S2), which are mounted on the PC board (Figure 1, below). These configuration switches allow you to configure the Model 1018RC for a wide range of applications. The ON/OFF orientation of the DIP switches is shown in figure 2 (below). Jumpers JP1 through JP4 are primarily used for factory configuration, and should be left in their default positions.

The Patton Model 1018RC short range modem rack card passes two “session” control signals (DTR/DCD), as well as two channel- independent flow control signals (RTS/CTS). This capability makes the Model 1018 suitable for SLIP (Serial Line Internet Protocol) and PPP (Point-to-Point Protocol) applications, as well as other serial applications requiring extra controls.

The Model 1018RC supports asynchronous data rates from 1.2 to

S1

S2

JP1 JP2 JP3 JP4

57.6Kbps, and distances to 2.4 miles. The Model 1018RC incorporates two V.54 test modes (local analog loop and remote digital loop), which can be activated from the front panel via the RS-232 interface. Additionally, a built-in V.52 BER test generator can output 511 and 511E bit patterns. Five easy-to-read LED indicators monitor power, transmit data, carrier detect, test mode and test pattern. For protection against ground loops and transient surges, the Model 1018RC incorporates both isolation transformers and Silicon Avalanche Diode surge suppressors.

The Model 1018RC is designed to mount in Patton’s 2U high 19” rack chassis. This 16-card chassis has a switchable 120/240 VAC power supply (optional 48 VDC) and mounts cards in a mid-plane architecture: The front card can be plugged into different rear cards. This means that the Model 1018RC card can have several interface options and can be switched with other Patton short haul cards.

3

Figure 1. Model 1018RC board, showing location of switches/jumper

	ON
ON

1 2 3 4 5 6 7 8

OFF

Figure 2. Close-up of DIP switches showing “ON” and “OFF” positions

4