Patton electronic 1082/I user manual Configuring DIP switch S2, S2-1 Activation Description

Configuring DIP switch “S2”

Use the eight DIP switches in S2 to enable 19.2 kbps or 144* kbps syn- chronous operation and set the loopback modes. The following table summarizes default positions of DIP switches S2-1 through S2-8. Detailed descriptions of each switch follow the table.

S2 Summary Table

Position	Function	Factory Default
S2-1	19.2 or 144* kbps Enable	Off
S2-2	Front Panel Switch Disabl e	Off
S2-3	Reserved	Off
S2-4	Reserved	Off
S2-5	Reserved	Off
S2-6	Reserved	On
S2-7	Reserved	Off
S2-8	Reserved	Off

Switches S2-1: 19.2 kbps or 144* kbps Synchronous Rate Enable

Use switch S2-1 to allow the Model 1082/I and Model 1082/144/I to oper- ate at the 19.2 kbps synchronous data rate, or to enable the Model 1082/ 144/I to operate at the 144* kbps synchronous data rate.

S2-1	Activation	Description
Off	Disabled	Synchronous data rate is 32–128 kbps as
		defined by switches S1-1 and S1-2
On	Enabled	Model 1082/I operates at synchronous 19.2 kbps
		data rate (see note). The Model 1082/144/I oper-
		ates at 144 kbps synchronous data rate (see note)

Note To operate at 19.2 kbps or 144 kbps, set switches S1-1 and S1-2 to the OFF position and switch S2-1 to ON (see section “Configur- ing DIP Switch S1” on page 12).

*144 kbps data rate is only available on the Model 1082/144/I.

19.2 kbps rate is available on all Model 1082 series modems except for the 1082/144/I.

15