Patton electronic 1082/I

4.0 CONFIGURATION

The Model 1082/I and Model 1082/144/I each are equipped with 16 DIP

switches that enable conﬁguration of the unit for a wide variety of appli-

cations. This section describes switch locations and explains the different

conﬁgurations.

4.1 CONFIGURING THE HARDWARE DIP SWITCHES

Using a small ﬂat-tip screwdriver, remove the protective cover located on

the underside of the Model 1092 (see Figure 4).

Figure 4.

Removing the cover to access DIP switches S1 and S2

511

G.703/G.704 Test Modes

511E

Model 1194E Single Mode Fiber - Quad G.703/G.704 Modem

511/RDL

TMER

NSStatus

NetLink 10BastT iDSL Modem

10BTDSL

Normal

511E/RBL

Link