Patton electronic 1193 user manual Section, Page, Radio And Tv Interference

		TABLE OF CONTENTS
	Section		Page
1.0	Warranty Information		2
	1.1	Radio and TV Interference
		Warning	2
	1.2	CE Notice	3
	1.3	Service	3
2.0	General Information		4

2.1Features

2.2Description

3.0 Configuration .........................................................................5

3.1Configure the Hardware DIP Switches

3.1.1Configure Model 1193

3.1.2Select RJ-48C or BNC Connectors

4.0 Installation .............................................................................9

4.1Connect the G.703/G.704 Network

4.1.1Connect Twisted Pair to G.703/G.704 Network

4.1.2Connect Coax Cable to the G.703/G.704 Network

4.2Connect the Fiber Interface

4.3Power Connection

4.3.1Universal AC Power

4.3.2DC Power

5.0 Operation .............................................................................12

5.1Power-Up

5.2LED Status Monitors

5.3Test Modes

5.3.1Local Loopback

5.3.2Remote Digital Loopback (RDL)

5.3.3The V.52 Test Pattern Generator

Appendix A - Specifications	17
Appendix B - Factory Replacement Parts and Accessories	19

1

1.0WARRANTY INFORMATION

Patton Electronics warrants all Model 1193 components to be free from defects, and willÑat our optionÑrepair or replace the prod- uct should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modifi- cation. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequen- tial damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 RADIO AND TV INTERFERENCE

The Model 1193 generates and uses radio frequency energy, and if not installed and used properlyÑthat is, in strict accordance with the manufacturer's instructionsÑmay cause interference to radio and tele- vision reception. The Model 1193 has been tested and found to com- ply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection from such interference in a commercial installation. However, there is no guarantee that interfer- ence will not occur in a particular installation. If the Model 1193 does cause interference to radio or television reception, which can be deter- mined by disconnecting the unit, the user is encouraged to try to cor- rect the interference by one or more of the following measures: mov- ing the computing equipment away from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a dif- ferent AC outlet (such that the computing equipment and receiver are on different branches).

WARNING: This device utilizes a class IIIB laser device which emits invisible light. There is potential for eye damage if proper caution is not taken. The laser port output is classified as class IIIA due to attenua- tion in the fiber cable. Eye protection should be worn at all times when the unit is operational and the laser port is not connected. The laser assembly should not be modified in any way. The fiber cable should never be disconnected from the laser device for any reason. The laser's wavelength is specified in the range of 1280 nm to 1330 nm with a maximum power output of 800 uw. Eye protection should be specified to handle the stated wavelength. Never look directly into to the laser port.

2