Patton electronic 1193 POWER CONNECTION 4.3.1 Universal AC Power 100-240VAC, DC Power, Power-Up

4.3 POWER CONNECTION

4.3.1 Universal AC Power (100-240VAC)

The Model 1193 uses a 5VDC, 2A universal input 100-240VAC, power supply (center pin is +5V). The universal input power supply has a male IEC-320 power entry connector. This power supply con- nects to the Model 1193 by means of a barrel jack on the rear panel. Many international power cords are available for the universal power supply (Refer to Appendix B for country-specific power cords).

The Model 1193 is ready for operation as soon as it is plugged into an AC outlet. The unit does not have a power switch.

4.3.2 DC Power

The 36-60 VDC DC to DC adapter is supplied with the DC version of the Model 1193. The black and red leads plug into a DC source (nominal 48VDC) and the barrel power connector plugs into the barrel power supply jack on the rear panel of the 1193. (See Figure 9).

5.0OPERATION

Once the Model 1193 is properly configured and installed, it should operate transparently. This section describes power-up, LED status monitors, and the built-in loopback test modes.

5.1 POWER-UP

To apply power to the Model 1193, read Section 4.3, and be sure that the unit is connected to the appropriate power source.

Set front panel switches to Normal. Then, plug the provided power adapter (see section 4.3) into the rear panel outlet of the Model 1193 and then into an acceptable power outlet (AC or DC depending on the model -UI or -DC). After both the local and remote Model 1193s are powered up, a synchronization process will occur to establish a link. The synchronization process should take approximately 5 seconds. Any time one of the Model 1193s lose power (i.e., in a lightning storm), the local and remote units will re-synchronize before they can resume data trans- mission.

To Power

Supply Jack

Barrel power connector

MADEINCHINABYSUNNY	:G01234567890S/N	OUTPUTPOWER:5WMAX	OUTPUT:+5V1.0A	INPUT:36-60V0.2AMAX	MODEL:SYD1106-0505	SWITCHINGPOWERSUPPLY		To -48VDC
							-Vin	Source
							+Vin

Black lead (-V)

Red lead (+V)

When the local and remote Models 1193 have established a link and are passing reliable data, the following LED conditions will exsit:

áFiber = GREEN

áE1 = GREEN

áLOS = OFF

á NS	= OFF
á ER	= OFF
á TM	= OFF

Figure 9. Connecting DC power to the 48V-PSM3 DC power supply.

WARNING! There are no user-serviceable parts in the power supply section of the Model 1193. Fuse replacement should only be performed by qualified service personnel. Contact Patton Electronics Technical support at (301)975- 1007, via our web site at http://www.patton.com, or by e-mail at support@patton.com, for more information.

5.2 LED STATUS MONITORS

The Model 1193 features six front panel status LEDs that indicate the condition of the modem and communication link. Figure 10 below shows the front panel location of each LED.

Figure 10. Model 1193 front panel

11 12