SmartNode 4960 Getting Started Guide | 3 • SmartNode installation |
|
|
Connecting the power supply
Do the following to connect the main power to the Model 4960:
Note Do not connect the power cord to the AC power outlet at this time.
1.Insert the female end of the AC power to the mains port (see figure 2 on page 16).
The internal power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the CAUTION power cord into the receptacle. Failure to do so could result in
equipment damage.
2.Verify that the AC power cord included with your router is compatible with local standards. If it is not, refer to “Contacting Patton for assistance” on page 43 to find out how to replace it with a compatible power cord.
3.Connect the male end of the AC power cord to an appropriate AC power outlet.
Port0 |
|
| |
T1/E1 | Port1 |
| |
| T1/E1 | Port2 | |
|
| T1/E1 | Port3 |
|
|
| T1/E1 |
Port | 0 | Port | 1 | Port | 2 | Port | 3 |
|
|
|
| ||||
T1/E1 T1/E1 | T1/E1 | T1/E1 |
|
| |||
Power |
|
|
|
|
|
|
|
Figure 6. Power LED (SmartNode 4960 shown)
4.Verify that the green Power LED is lit (see figure 6).
Installing the gateway router | 28 |
