Patton electronic 4960 Series manual Load a new application image SmartWare via the serial link

SmartNode 4960 Getting Started Guide 4 • Initial configuration

Using default protocol (TFTP)

-

Raw file loaded 0x01800100-0x0199ca6b, 1689964 bytes, assumed entry at 0x01800100

RedBoot> fis delete -n 1

Delete image 1 - continue (y/n)? y

... Erase from 0x60030000-0x601cc974: ..........................

RedBoot> fis create

Use address 0x01800100, size 1684402 ? - continue (y/n)? y

... Erase from 0x60030000-0x601cb3ba: ..........................

... Program from 0x00011eec-0x00011ef4 at 0x60030000: .

... Program from 0x01800100-0x0199b4b2 at 0x60030008: ..........................

... Program from 0x00011eec-0x00011ef4 at 0x60030000: . Image successfully written to flash

RedBoot>	fis list -l
Id Address		Length	State	Description
Entry		Load Addr		Version

--------------------------------------------------------------------

1 0x60030000		1693438	valid	SmartWare R2.10 BUILD28015
0x01800100		0x01800100		V2.10
RedBoot>	go
Starting	’SmartWare R2.10		BUILD28015’ at 0x01800100 via 0x01800100

Load a new application image (SmartWare) via the serial link

The Bootloader supports the ‘X-Modem’ and ‘Y-Modem’ protocols to download application images via the serial link of the console. Do the following to initiate the download:

Step	Command	Purpose
1	RedBoot> load -r -v -m {	Downloads an application image into the volatile memory
	xmodem ymodem } -b	(RAM) from where the SmartNode could directly execute it.
	base_address	‘xmodem’ or ‘ymodem’: Specify the protocol to be used, X-
		Modem or Y-Modem
		base_address: memory location where to store the application
		image. Use the default address 0x1800100
		Execute the above RedBoot command first, then start the trans-
		fer from the terminal program with the command ‘Send file via
		X-Modem’ (or similar).
5	RedBoot> fis delete -n 1	Deletes the first application image.
		Reply with ‘y’ to the confirmation request.
6	RedBoot> fis create	Stores the downloaded application image to the permanent
		memory (flash:).
		Reply with ‘y’ to the confirmation request.
7	RedBoot> fis list -l	Checks whether the image has been successfully stored,
		whether it is the desired Release and Build, and whether it is
		valid.

Bootloader 36