Patton electronic 4960 manual Line Setup, Configuring PPPoE, Introduction

SmartNode 4960 Getting Started Guide 5 • G.SHDSL Basic Configuration

Introduction

The SN4960 model has an option for a built-in G.SHDSL modem. The modem appears in the configuration as "port dsl 0 0" mode.

Profile

napt

WAN

port dsl 0\ 0\

pvc

vpi 8 vci 35

pppoe

session MyISP

use
profile
WAN	napt

WAN

interface

bind subscriber
	MySubscriber
interface
bind	router
WAN

Subscriber PPP MySubscriber

context

ip

Figure 9. Configuring the G.SHDSL card for PPPoE

The Modem setup uses IP messages within its own subnet: 192.0.2.0/24. SmartNodes with built-in modems cannot use this subnet in any other way.

CAUTION

Note For information about the specifications of the G.SHDSL daughter card, see Appendix B, “Specifications” on page 49.

Line Setup

There is no line modulation setting. The modems automatically adapt to the bit rate and modulation used. The status LED on the back of the device is blinking while the modem attempts to connect and lit when the link is established. If the modem keeps blinking, check the cabling,

Configuring PPPoE

Figure 9 explains how to configure PPPoE on the SmartNode’s built-in G.SHDSL card. To configure the DSL port for PPPoE, first you need to log in to the SmartNode via the CLI and enter configuration mode.

login: administrator

password: <enter> SN4xxx>enable SN4xxx>#configure

Introduction 39

VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030