Appendix C, DB9F | Patton electronic NetLink-E1 2715 guide

	APPENDIX C		APPENDIX D
PATTON MODEL 2715			PATTON MODEL 2715
FACTORY REPLACEMENT PARTS			INTERFACE PIN ASSIGNMENTS
	AND ACCESSORIES
Patton Model #	Description		RJ-48C E1 Network Interface
Patton Model #	Description		(RJ-48S Female Modular Jack)
2715/CM/UI	V.35 to E1 Converter (V.35 M/34 Male,
	UI)
10 - 09F	6 Foot Control Port Cable, 25 mm to	Pin #	Signal
10 - 09F	6 Foot Control Port Cable, 25 mm to	1	RX Data (TIP)
	DB9F	2	RX Data (RING)
08055DCUI	Universal Input Power Supply	4	TX Data (TIP)
08055DCUI	Universal Input Power Supply	5	TX Data (RING)
10-CISCO-V35FT-1	Cable, V35 (M/34) Female To LFH60
	Male
07M2715	User Manual

Image 19

Contents

User Manual Warranty Statement Patton Model Table of ContentsGeneral Information Tel 301 Email support@patton.com Service InformationRadio and TV Interference CE and Telecommunication Approvals 2715 as the Interface between the Telco and CPE FeaturesGeneral Product Description Supported Applications Line Coding Options DIP Switch ConfigurationSwitch SET Summary Table Switch SW1 Line Coding Clock Modes MULTIFRAMEG.704CRC-4 MF Unframed G.703 SW3 SW4 Software Configuration Helpful Hints Introduction to Main Menu Line Format G.703 default Options G.703, G.704 System ConfigurationLine Coding HDB3 default Default Config Source Switch default Options EEPROM, Switch CRC-4 Setting Disabled default Options Enabled, DisabledCAS MF Setting Disabled default Options Enabled, Disabled 54 Loops Enabled default Options Enabled, Disabled Local Loop Idle default System Diagnostics Spacebar Remote Loop Idle defaultTest Pattern Idle default Options Idle or Sending Error Insertion Off default Options On, Off Unit Options Current DIP Switch SettingsPassword NI Status DTE Interface Connection Loop TimeoutSet to Default Configuration Service Information RXD Power ConnectionLED Descriptions TXD ERR Loop V.54 & Telco DiagnosticsLOS ALM 2047 BIT Error Rate V.52 DiagnosticsError Insertion to on 511 Cable Recommendations Specifications DB9F Appendix C Jumper Position for Power via Pin KK Connector, Terminal InterfacePower Supply Interface Jumper Position for Power via DC Power Jack default

APPENDIX C