Paxar 9412 F i n i n g t h e P r i n t C o n t r o l P a c k e t, C1. C Print Control Packet

B6. cut_posn -99to 99 in 1/203 inch. Use 0 for these printers.

Example {I,B,0,0,1,10,0 p }

Indicates black mark and thermal direct stock has been loaded, causes the printer to operate in on-demand mode and feeds the supply approximately .05 inches up before printing the format on each label (10/203 inches).

D e f i n i n g t h e P r i n t C o n t r o l P a c k e t

Use the print control packet (C) to set the contrast, print, and margin adjustment, print speed, and printhead width.

Syntax {I,C,contrast,print_adj,margin_adjust, speed_adj,ph_width p }

C1. C Print Control Packet

C2. contrast -390to 156. 0 is the default for all printers.

C3. print_adj -99to 99 in 1/203 inch. 0 is the default for all printers. Adjusts where data prints vertically on the supply. Increase the print position to move print up, decrease to move print down.

C4. margin_adj -99to 99 in 1/203 inch. 0 is the default for all printers. Adjusts where data prints horizontally on the supply. Increase the margin position to move print to the right, decrease to move print to the left. Margin and print position are format adjustments. They will not affect the supply position.

C5. speed_adj Print speed. Use 0 for these printers.

C6. ph_width Width of the printhead in dots. Use 0 for these printers.

Example {I,C,0,-20,-10,0,0 p }

Uses the default contrast, moves print 0.1 inch closer to the bottom of the supply (20/203 inches) and .05 inch to the left on the supply (10/203 inches), prints at two inches per second, and uses the default printhead width.

Configuring the Printer 3-11