Paxar 9430R Attaching the Belt Clip

1-8 Getting Started

Tab

Attaching the Belt Clip

1. The printer comes with a belt clip.

2. Turn the printer over.

3. Attach the belt clip as shown. Insert the printer’s

round knob into the latch and pull up until it “clicks”

into place.

4. Attach the belt clip to your belt by looping the strap

around your belt and snapping it into place.

To remove:

1. Remove the belt

clip from your belt.

2. Remove the printer

from the belt clip

by squeezing the

tabs and pulling

the clip down.

Strap

Contents

Main hand-held portable table-top Page Page TABLE OF CONTENTS Page GETTING STARTED Operators Handbook Unpacking the Printer Programming Information Programmer's Manual Battery and Safety Information Installing the Battery Charging the Battery Using the AC Adapter Reading the LED This table explains the LED indicators. Programmers Manual Setting the DIP Switches Page Attaching the Belt Clip LOADING SUPPLIES Tearing Supply Using Different Size Supply Rolls For one-inch wide supply: For two-inch wide supply: Page USING THE PRINTER Printing Programmers Manual Using the Magnetic Stripe Reader Page CLEANING Page TROUBLESHOOTING Page Printing a Test Receipt Page SPECIFICATIONS A Printer Specifications Supply Specifications Ordering Supplies Options and Accessories Not for use with printers M09430R03, M09430R04, M09430R09, and M09430R10.