Paxar 9430R Tearing Supply

2-2 Loading Supplies

3. Drop the supply into the well. Make sure the supply

unwinds from the bottom as shown.

4. Position the supply between the printhead guides.

5. Make sure 2-3 inches of supply extends past the

printhead.

6. Close the supply door.

7. Turn on the printer.

Tearing Supply

The printer’s supply door acts as a tear bar. Tear down

against the tear bar to remove receipts.

NOTE: Do not tear supply up against the printhead or

sideways, because the supply door may open.

Tear Bar

Contents

Main hand-held portable table-top Page Page TABLE OF CONTENTS Page GETTING STARTED Operators Handbook Unpacking the Printer Programming Information Programmer's Manual Battery and Safety Information Installing the Battery Charging the Battery Using the AC Adapter Reading the LED This table explains the LED indicators. Programmers Manual Setting the DIP Switches Page Attaching the Belt Clip LOADING SUPPLIES Tearing Supply Using Different Size Supply Rolls For one-inch wide supply: For two-inch wide supply: Page USING THE PRINTER Printing Programmers Manual Using the Magnetic Stripe Reader Page CLEANING Page TROUBLESHOOTING Page Printing a Test Receipt Page SPECIFICATIONS A Printer Specifications Supply Specifications Ordering Supplies Options and Accessories Not for use with printers M09430R03, M09430R04, M09430R09, and M09430R10.