Peavey operation manual TECHNISCHE DATEN DES TRANSTUBE 110 EFX

TECHNISCHE DATEN DES TRANSTUBE® 110 EFX

POWER AMP SECTION:

Rated power and load:

40 Watts (RMS) into 6 Ohms

Power @ clipping (typically): (5% THD, 1 kHz, 120 VAC line) 35 Watts (RMS) into 6 Ohms

Total harmonic distortion:

Less than 0.5% THD, 100 mW to 15 Watts (RMS), 100 Hz to 10 kHz

Power amp hum and noise @ nominal input level:

Volume (minimum level): 10

Preamp input (clean channel):

Impedance: High Z, 250 k Ohms

Nominal input level: -14 dBV, 200 mV (RMS)

Minimum input level: -24 dBV, 64 mV (RMS)

Effects send:

Output impedance: 1k Ohms

Nominal output Level: -7.4 dBV, 425 mV (RMS)

Effects return:

Input impedance: 31 k Ohms

Nominal input level: -7.4 dBV, 425 mV (RMS)

(20 Hz to 20 kHz, unweighted)	Headphone output:
Greater than 82 dB below rated power	Load impedance: 8 Ohms or greater
	Nominal Power Output: 30 mW (RMS) into
Power Consumption:
75 Watts 50/60 Hz, 120 VAC	8 Ohms
	(Stereo jack, monaural signal disconnects
PREAMP SECTION:	internal speaker when phone plug is inserted.)
The following specs are measured @ 1 kHz

with the controls preset as follows:	System Hum and noise @ nominal input
Channel select: CLEAN	level:
EQ voicing switch: MODERN	(20 Hz to 20 kHz, unweighted)
Low, mid, and high: 5	Greater than 75 dB below rated power
Pre gain and post gain: 10
Efx adjust: OFF
Reverb: OFF
Delay: OFF
Volume (nominal level): 5

Änderungen der technischen Daten vorbehalten.

29