M O N O M O D E O P E R AT I O N
F R O N T PA N E L
1
2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 |
POWER SWITCH (1)
This
MODE SWITCH (2)
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS DOES NOT BREAK BOTH SIDES OF THE MAINS. HAZARDOUS ENERGY MAY BE PRESENT INSIDE THE ENCLOSURE WHEN THE POWER SWITCH IS IN THE OFF POSITION.
This switch selects between stereo
INPUT GAIN CONTROL (3)
This control is used to optimize the gain between the mixer and the power amps.The control range is between 0 dB and +12 dB.
LOW GAIN CONTROL (4)
This controls the output level of low frequency signals (those below the selected crossover point) present at the low output XLR.
HIGH GAIN CONTROL (Channel 1) (5)
This function is
CROSSOVER SELECTOR CONTROL (lows/mids) (6)
This allows the user to choose their desired crossover point for lows and mids. Control range is between 100 Hz and 1 kHz or 1 kHz and 10 kHz depending on the position of the Range Switch.
RANGE (x10) SWITCH (lows/mids) (7)
This switch multiplies the value indicated on the Crossover Selector Control times 10.When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. Range x10 is indicated by the illumination of the red LED above the switch.
INPUT GAIN CONTROL (Channel 2) (8)
This function is non operational in MONO Mode.
MID GAIN CONTROL (9)
This controls the output level of mid signals (those below the selected crossover point) present at mid output XLR.
HIGH GAIN CONTROL (10)
This controls the output level of the highs (signals above the selected crossover point) present at high output XLR.
11