S T E R E O M O D E O P E R AT I O N
F R O N T PA N E L
1
2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 |
POWER SWITCH (1)
This
MODE SWITCH (2)
WARNING 
THE ON/OFF SWITCH IN THIS APPARATUS DOES NOT BREAK BOTH SIDES OF THE MAINS. HAZARDOUS ENERGY MAY BE PRESENT INSIDE THE ENCLOSURE WHEN THE POWER SWITCH IS IN THE OFF POSITION.
This switch selects between stereo
INPUT GAIN CONTROL (Channel 1) (3)
This control is used to optimize the channel 1 gain between the mixer and the power amps for channel 1.
Control range is between 0 dB and +12 dB.
LOW GAIN CONTROL (Channel 1) (4)
Controls output level of channel 1 low frequency signal (signal below the selected crossover point) present at channel 1 low output XLR.
HIGH GAIN CONTROL (Channel 1) (5)
Controls output level of channel 1 high frequency signal (signal above the selected crossover point) present at channel 1 high output XLR.
CROSSOVER SELECTOR CONTROL (Channel 1 Lows/Highs) (6)
Allows user to choose their desired crossover point for lows and highs for channel 1. Control range is between 100 Hz and 1 kHz or 1 kHz and 10 kHz depending on the position of the Range Switch.
RANGE (x10) SWITCH (Channel 1 lows/highs) (7)
This switch multiplies the value indicated on the Crossover Selector Control times 10.When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. Range x10 is indicated by illumination of the red LED above the switch.
INPUT GAIN CONTROL (Channel 2) (8)
This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2. Control range is between 0 dB and +12 dB.
LOW GAIN CONTROL (Channel 2) (9)
Controls output level of channel 2 lows signal (signal below the selected crossover point) present at channel 2 low output XLR.
8
