HIGH GAIN CONTROL (Channel 2) (10)
This controls output level of channel 2 highs signal (signal above the selected crossover point) present at channel 2 high output XLR.
CROSSOVER SELECTOR CONTROL (Channel 2 lows/highs) (11)
This allows users to choose their desired crossover point for lows and highs for channel 2.The control range is between 100 Hz and 1 kHz or 1 kHz and 10 kHz, depending on the position of the Range switch.
RANGE (x10) SWITCH (Channel 2 lows/highs) (12)
This switch multiplies the value indicated on the Crossover Selector Control times 10.When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. Range x10 is indicated by the illumination of the red LED above the switch.
R E A R PA N E L
4 | 3 | 2 | 1 |
IEC MAINS CONNECTOR (1)
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly.To prevent the risk of shock or fire hazard, always make sure that the equalizer and all associated equipment is properly grounded.
Incorporated into this IEC MAINS CONNECTOR is the MAINS FUSE HOLDER. If for any reason you are unable to power up this unit, remove the fuse by pulling out the holder. Check to see if the fuse is operational. If not, then replace with a fuse of the appropriate value and rating. If the fuse continues to fail contact your nearest Certified Peavey Service Center.
INPUT (Channel 1) (2)
This XLR female
LOW OUTPUT (Channel 1) (3)
This XLR male
HIGH OUTPUT (Channel 1) (4)
This XLR male
9
