Peavey E110 Master DI Ground Lift, XLR DI Output, Line Output, Stereo Link OUT Jack, Tuner Output

Session 300 Rear Panel

5MASTER DI GROUND LIFT

Engaging this switch will disconnect the ground connection from pin 1 on the DI output XLR

Jack. Usually this should be left in the "out" position; however, there may be certain situations when connect- ing from the DI jack to another device that a hum is produced due to a ground loop. If this happens, then press- ing the ground lift switch in should eliminate the problem.

6XLR DI OUTPUT

The XLR jack is a low-impedance, balanced output for connecting directly to a stage box or mixer for live or studio use.

71/4" LINE OUTPUT

Direct line-level balanced 1/4" output for connecting directly to a stage box or mixer for live or studio use.

8STEREO LINK OUT JACK

Connecting this to the Power Amp Input on another Session 300 (5) will complete the stereo image in the ef- fects section. In this example, this amplifier would be the first amplifier and the front-panel controls would be active.

9CHANNEL III RCA INPUT JACKS

RCA type input jacks for connecting outboard gear such as CD players, MP3 players or drum machines to Chan- nel III of the Session 300.

10TRS 1/4" LINE OUT FOR CHANNELS I AND II

Direct line level balanced 1/4" output for connecting either channel directly to a stage box or mixer for live or studio use. This output is prior to the digital effects section, so the front-of-house engineer can have a pure instrument signal.

11XLR DIRECT INTERFACE FOR CHANNELS I AND II

Low-impedance, balanced output for connecting either channel directly to a stage box or mixer for live or studio use. This output is prior to the digital effects section so the front-of-house engineer can have a pure instrument signal.

12DI OUTPUT EQ PRE/POST SWITCH FOR CHANNELS I AND II Switches the channel-specific DI outputs from pre or post EQ source.

13DI OUTPUT GROUND LIFT FOR CHANNELS I AND II

Pressing this switch "in" will disconnect the ground connection from pin 1 on the DI output XLR Jack. Usually this should be left in the "out" position; however, there may be certain situations when connecting from the DI jack to another device that a hum is produced due to a ground loop. If this happens, then pressing the Ground Lift Switch should eliminate the problem.

14PRE-EQ EFFECTS LOOP SEND FOR CHANNELS I AND II

For sending the signal to an outboard effects processor(s). The Session 300 is equipped with separate effects loops for channels 1 and 2. This effects send is pre-eq.

15PRE-EQ EFFECTS LOOP RETURN FOR CHANNELS I AND II

The signal return from your outboard effects processor(s). This effects return is pre-eq.

16TUNER OUTPUT

Connect this to your outboard tuner. When the Tuner/Mute switch is engaged, this output remains active for quiet tuning. This output could also be used as an auxiliary line output.

20