Peavey E110 manual Digital Section, Stereo Link Output, Power AMP Input, Dimensions/Weight

ECOUSTIC® E300

SPECIFICATIONS

POWER AMPLIFIER SECTION: General:

Bi-amp system with independent, class-D, bridge-tied load outputs crossed over at 3KHz (24dB/octave filter)

Amplifier frequency response = 20 – 20KHz

Power Consumption:

USA/Japan: 100 – 120vac 50/60Hz =

90 Watts

Europe/Other: 220 – 240vac 50/60Hz

=90 Watts

Rated Power:

*Measurements taken at 120vac line; channels measured independently; ratings at <5% THD

104 Watts continuous into 8 ohm, series woofer load (400Hz sine wave)

104 Watts continuous into 8 ohm, planar tweeter (5KHz sine wave)

PREAMP SECTION:

Channel 1 / Channel 2:

Input impedance = 3M ohm (1/4" jack); <10K ohm (balanced XLR)

Phantom power = +48V (XLR) / +9V (1/4" jack)

Nominal signal input level = -11.7dBu

Maximum signal input level = +4.69dBu

Channel 3 / Aux In:

Input impedance = 330K ohm (front 1/4" jack); 10K ohm (rear, summed phono jacks)

Nominal signal input level = -6.90dBu

Maximum signal input level = +20dBu

DIGITAL SECTION:

32-bit floating point DSP Audio converter = 24-bit Sample rate = 48kHz System latency = 0.5ms

PATCHING INPUT/OUTPUT JACKS

CHANNEL 1 & 2 DI / MASTER LINE OUT:

XLR/DI output impedance = 200 ohm Minimum load = 600 ohm

Maximum signal output level = +20.4dBu

SYSTEM NOISE (A-WEIGHTED) Channel 1 DI = 89.8dB Channel 2 DI = 84.1dB Master line out = 80.4dB

STEREO LINK OUTPUT:

*Output is right channel of the digital effects; E300 outputs left channel in this mode

Output impedance = 200 ohm Minimum load = 600 ohm

Maximum signal output level = +4.08dBu

Noise floor = 79dB (A-weighted)

POWER AMP INPUT:

Input impedance = 10K ohm

Nominal signal input level = +2.22dBu

Maximum signal input level = +7.32dBu

DIMENSIONS/WEIGHT

Width = 23.75” (60.33 cm), Height

=15.38” (39.06 cm), Depth = 13.63” (34.62 cm)

49.5lbs. (22.5 kg)

22