Rear Panel-Export
12
13
Footswitch (12)
EXPORT 220-230/240 VAC 50/60 Hz ONLY
14
15 | 16 | 17 | 18 |
This 1/4" mono jack is provided for use with a
Pentatone (13)
This switch allows the user to select one of the five standard settings in conjunction with the footswitch.
Speaker Outputs (14)
These 1/4" mono jacks provide two connections for speaker cabinets.
Impedance Selector (15)
This switch must be set properly to match the speaker cabinet used. If two 16 ohm cabinets are being used the switch should be set to 8 ohm.
Voltage Selector (16)
Selects between
Line Cord (230 V units only) (17)
If it is necessary to use the Penta™ without proper grounding facilities, suitable grounding adapters should be used. Greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles.
note: for UK only
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings identifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or colored red.
Fuse (18)
A F3A/250 amp fuse is located within the cap of the fuseholder. It must be replaced with the same type and value in order to avoid damage to the equipment and to prevent voiding the warranty. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair.
WARNING: The fuse should only be replaced when the power cord has been disconnected from its power source.
11