Mounting and Removing Flat Panel Screen
WARNING
•Always use an assistant or mechanical lifting equip- ment to safely lift and position the plasma television.
NOTE: For security, replace safety screw in each tilt bracket with M5 x 30 security screw (HH) using wrench (II).
Adjust brackets to full back tilt position and tighten. Hook tilt brackets (BB and CC) onto wall plate (AA). Then slowly swing screen in as shown. Turn safety screws, using wrench (II), clockwise till fully tightened down and screw tip securely contacts bottom of the wall plates as shown in detail 1. of figure 5.1. Center of screen can be adjusted horizontally no more than 4" from center of the wall plate configuration, if desired as shown in figure 5.2.
NOTE: To lock the screen down, tighten safety screws to wall plate using a wrench (II) as shown in detail 1.
To remove screen from mount, loosen safety screws, swing screen away from mount, and lift screen off of mount.
CAUTION
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
•Be careful not to pinch fingers when pushing screen from the bottom.
Adjusting the Tilt Angle of the Flat Panel Screen
Adjust tension knobs shown in detail 2 to desired tension, balancing your screen size and weight. The tension knob, without changing the bracket tension, can be pulled out, away from the bracket and turned independently of the knob post for readjustment as shown in Detail 3.
Push or pull from top or bottom of screen to adjust tilt as shown in figure 6.1. The tilt can be adjusted to a maximum of 15° forward or 5° backward.
BB and CC
AA AA
SAFETY
SCREW
DETAIL 1
fig 5.1
4"
CS
CS = center of screen
fig 5.2
LOCATOR
HOLE
TENSION
KNOB
TILT POSITION |
| IncreLok™ |
HOLES | DETAIL 2 | TILT LOCKING |
| SCREW |
TENSION
KNOB
NOTE: To lock the screen into the desired tilt |
| |
position, use locator hole to find tilt position hole. | fig 6.1 | |
Tighten IncreLok™ tilt locking screws on both tilt | ||
| ||
brackets as shown in figure 6.1 and detail 2. | DETAIL 3 | |
11 of 33 | ISSUED: |
© 2006 Peerless Industries, Inc. All rights reserved. Onemount is a trademark and Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.