Pelco 100BASE-TX, 100BASE-FX manual Features of the FX82052 Ethernet switch include the following

Features of the FX82052 Ethernet switch include the following:

•User-selectable networking functions for each 10BASE-T/100BASE-TX port:

–Autonegotiation between 10 Mbps and 100 Mbps data rates and between full-duplex and half-duplex modes

–10 Mbps or 100 Mbps selectable

–Full-duplex or half-duplex mode selectable

–Enabling/disabling of flow control

NOTE: The 100BASE-FX fiber ports are automatically forced to full-duplex 100 Mbps operation.

•Auto MDI/MDI-X (Medium Dependent Interface/Medium Dependent Interface Crossover) operation

•Compliant with IEEE 802.3, 802.3u, and 802.3x standards

•Multimode fiber support for distances up to 2 km (applicable to FX82052 versions using one fiber per fiber port) or up to 6 km (applicable to FX82052 versions using two fibers per fiber port)

•Single-mode fiber support for distances up to 46 km

•Integrated wavelength division multiplexing (WDM), which allows bidirectional data to be transmitted in one fiber (applicable to FX82052 versions using one fiber per fiber port)

•Compatible with other Ethernet equipment:

–10BASE-T/100BASE-TX compatibility with all Pelco® and third-party 10BASE-T/ 100BASE-TX Ethernet devices

–Fiber optic compatibility with all Pelco Ethernet devices that support WDM (applicable to FX82052 versions using one fiber per fiber port)

–Fiber optic compatibility with all Pelco Ethernet devices that do not support WDM (applicable to FX82052 versions using two fibers per fiber port)

–Fiber optic compatibility with third-party 100BASE-FX Ethernet devices (applicable to FX82052 multimode ST and SC versions using two fibers per fiber port)

•Laser diode for transmission of optical signals

NOTE: The FX82052 switch is a Class 1 laser product that complies with FDA radiation performance standard 21CFR Subchapter J and with IEC 60825-1 Edition 1.2, 2001-08.

•Environmentally hardened

•Designed to meet NEMA TS 2 and Caltrans traffic signal control equipment standards for ambient operating temperature, mechanical shock and vibration, humidity with condensation, high-line/low-line voltage conditions, and transient voltage protection

NOTE: Conformal coating is required for operation in environments with relative humidity above 95 percent (condensing).

•No performance adjustments required

•12 VDC or 24 VAC power supply

•Stand-alone and rack-mountable modular design

•LED indicators for monitoring of fiber redundancy mode status, optic signal/laser status, 100BASE-FX port status including far end fault indication (FEFI), 10BASE-T/100BASE-TX port status, and operating power

C2607M (2/07) 9