Pelco 500 Series manual RGB/DVI Mode Menu Field Definitions

RGB/DVI Mode Menu Field Definitions

NOTE: You cannot change the language on this menu. You must use the Video1, Video2, S-Video, Component Mode Menu to change the language. The language will then be changed for both menus.

Input: Select RGB or DVI.

Contrast: Adjusts black level of the video screen image (0 to 100).

Brightness: Adjusts white level of the video screen image (0 to 100).

H-Position:(RGB only; dimmed in DVI mode.) Adjusts the horizontal position (-35 to +35).

V-Position:(RGB only; dimmed in DVI mode.) Adjusts the vertical position (-15 to +15).

Frequency: (RGB only; dimmed in DVI mode.) Adjusts the horizontal size of the screen image (-3 to +3).

Phase: (RGB only; dimmed in DVI mode.) Adjusts image distortion appearing as horizontal noise on the screen (0 to 63).

Auto Position Override: (May be dimmed.) Select DISABLE, 1024x768, 1280x768, 1360x768, or 1366x768. (If the display is distorted or shifted at a resolution of 1366 x 768, you should adjust the resolution here by manually selecting 1366 X 768.)

Panel Buttons: Select UNLOCK or LOCK. Locks/unlocks the buttons on the front panel.

PIP: Select Setup for the picture-in-picture. Then select one of the following:

•PIP Input: Select VIDEO 1, VIDEO 2, or S-VIDEO.

•PIP Location: Select the PIP position as T/L (top left), T/R (top right), B/R (bottom right), or B/L (bottom left).

•PIP Size: Select the PIP size as LARGE or SMALL.

•PIP Options: Select PIP, POP 4:3, POP 16:9, or PIP OFF.

•PIP Swap: Select SWAP to interchange Main with PIP. (Dimmed in DVI mode.)

NOTES:

•When using POP 16:9, one image will be 16:9 while the other will be a 4:3 aspect ratio.

•PIP and POP modes only work with certain inputs. For example, you cannot use a component or DVI subpicture with an RGB as the main picture.

Aspect Ratio: Select 16:9 or 4:3. (Dimmed in DVI mode.)

OSD Setting: Select Setup for the on-screen display. Then select one of the following:

•OSD H.Position: Adjusts the OSD horizontal position (0 to 100).

•OSD V.Position: Adjusts the OSD vertical position (0 to 100).

•OSD Transparency: Adjusts the OSD transparency (0 to 100). The lower the number, the more transparent the menu will become over the background.

•OSD Display Time: Select 5 SEC, 10 SEC, 30 SEC, 60 SEC, or OFF.

Color Temperature: Select 6500 K, 9300 K, or User. If you select User, then select from the following calibrations:

•R-Gain:Adjusts gain for red (-50 to +50).

•G-Gain:Adjusts gain for green (-50 to +50).

•B-Gain:Adjusts gain for blue (-50 to +50).

•R-Offset:Adjusts the offset (or cut) for red (0 to 100).

•G-Offset:Adjusts the offset (or cut) for green (0 to 100).

•B-Offset:Adjusts the offset (or cut) for blue (0 to 100).

•Reset: Select Restore to return to the original color temperature settings.

Default Setting: Select Restore to return to the default settings.

Information: Select Information to access Pelco headquarters information.

18 C2937M-A (5/07)