Pelco C1692M ,

C1692M (12/05) 31

INSTALL SOFTWARE

To install software:

1. After the DX8000 reboots from the installation CD the DX8000 Recovery dialog box opens.

Figure 30.

DX8000 Recovery Dialog Box

2. Carefully read the warning presented in the dialog box, and type the word Yes to conﬁrm that you want to continue

the reinstallation process.

3. Click the Proceed button to continue the installation procedure. The Partition Size Veriﬁcation dialog box appears.

Figure 31.

Partition Size Veriﬁcation Dialog Box







Contents

Main Contents List of Illustrations Introduction TOOLS NEEDED Qty Description PARTS LIST Getting Ready Page Prepare Unit for Drive Installation OPEN THE UNIT CHASSIS Page COMPONENT LAYOUT REAR OF DVR FRONT OF DVR Move the Front Cross-Brace Page Disconnect the Data and Power Cables Page Page Replace the Primary Hard Disk REMOVE THE ORIGINAL SYSTEM DRIVE MOUNT THE NEW SYSTEM DRIVE Page SET THE SYSTEM PRIMARY JUMPER Page RECONNECT THE DATA AND POWER CABLES Page Page Page Page Page Page Page Page Install Software on the New Drive CONFIGURE SYSTEM TO BOOT FROM CD/DVD AwardBIOS Setup Utility Page AwardBIOS Setup Utility F1 Help ESC Exit Main Advanced Power Boot Exit AwardBIOS Setup Utility F1 Help ESC Exit Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATION REVISION HISTORY