14 C2444M-C (1/04)
<Label Position>
Labels can be placed anywhere on the monitor. This feature allows you to customize the
appearance of your monitor screen.
The following labels are not set at fixed positions:
PRESET LABEL
ZONE LABEL
ALARM 1
ZOOM RATIO - XXX.XX
AZIMUTH1/ELEVATION2 - XXX°/-XX°
DIRECTION - NE
ALERT MESSAGE3*
To set a label position:
1. Use the joystick to position the cursor beside a label.
2. Press Iris Open.
3. Use the joystick to move the label up, down, left, and/or right.
4. Press Iris Open.
5. Repeat steps 1 through 4 to position other labels.
6. Position the cursor next to Save and Exit. Press Iris Open to save settings and exit
menu.
1Azimuth is the pan angle from 0° to 359°.
2Elevation is the tilt position from 0° (horizon) to -90°.
3 The alert message is the warning displayed on the monitor if pressure, temperature, or dew
point inside the dome reach unacceptable levels.
BACK
EXIT
PRESET LABEL 2 (SECS)
ZONE LABEL 2 (SECS)
ZOOM 2 (SECS)
AZIMUTH/ELEVATION 2 (SECS)
DIRECTION OFF
ALARM MESSAGE 2 (SECS)
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
[ZONE LABEL-------]
[PRESET LABEL-------]
[ALARM 1-------]
[ALERT MESSAGE-------]*
SAVE AND EXIT
CANCEL AND EXIT
HELP
XXX
o
/-XXX
o
NE
XXX.XX
LABEL POSITION
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.