Illustrates the front panel of the SX8205R module | Pelco c2626M

FRONT PANEL

Figure 2 illustrates the front panel of the SX8205R module.

Figure 2. Front Panel of SX8205R Module

ìReset Button: Restarts the unit

îPower LED: Pelco badge

NOTE: For additional information about the Power LED, refer to Troubleshooting on page 15.

8	C2626M (2/07)

Image 8

Pelco c2626M manual Illustrates the front panel of the SX8205R module

Contents

Ethernet Switch List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television Interference Product Overview Description Models Rack mount chassis Front Panel of SX8205R Module Reset Button Restarts the unit Illustrates the front panel of the SX8205R module Rear Panel Illustrates the rear panel of the SX8205R module Installation Package Contents Autonegotiation is enabled by default Flow control is disabled by defaultTable A. TX Mode Switch Settings Flow control default setting Mounting Mounting the SX8205R Module Into a Rack Mounting the SX8205R Module Using the Wall Clip Connections 10BASE-T/100BASE-TX connections Troubleshooting Table C. Troubleshooting with Rear-Panel Indicators Desired, refer to SettingAmber 10BASE-T link is If 10BASE-T operation is Established 10 for information Setting of the remote Not lit 10BASE-T orDo any of the following as 100BASE-TX link Cable Applicable Cannot be Duplex mode Duplex mode LinkIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplex Green Port is set to If 100BASE-TX full-duplex Flashing green Port is set to100BASE-TX half Replace cable if it is Table C. Troubleshooting with Rear-Panel Indicators Specifications Link/activity and speed, duplex/collision and speed Appendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinouts Product Warranty and Return Information ISO9001