Manuals / Pelco / Household Appliance / Home Security System

Pelco C3422M-B manual Preinstallation

Models: C3422M-B

1 20
Download 20 pages 63.31 Kb
Page 2
Image 2
Preinstallation

Preinstallation

NOTE: This manual is designed to be a reference tool for the installation of your system. For best results and ease of installation, the dome system should be assembled, pressurized, and tested before installation. A Pressurized Spectra® IV cable harness (supplied with the back box) is required to test and monitor the pressurized dome.

1.Install the fiber optic module: Open the hinged door to the back box by pushing the tab lock towards the wall of the unit and lifting the door open. Remove the plug from the 16-pin connector. Install the module in the 16-pin connector. Secure the module to the circuit board standoff using the screw and lock washer provided.

16-PIN

CONNECTOR

Figure 1. IInstalling the Fiber Optic Module

2.Connect the back box fiber optic connector to the mating connector on the module. Be sure to route the fiber optic cables between the plastic housing and the outer wall of the back box before attaching the two connectors. Follow all applicable instructions provided by the manufacturer of the fiber optic module.

NOTE: All bends in the fiber optic cable must be 1-inch diameter or greater.

Figure 2. Connecting the Back Box Fiber Optic Connector

2

C3422M-B (3/08)

Page 1 Page 3
Page 2
Image 2
Pelco C3422M-B manual Preinstallation
Page 1 Page 3

FAQ

What is the purpose of this manual?

This manual is designed to be a reference tool for the installation of your Pelco Home Security System, model C3422M-B.

What is required to test and monitor the pressurized dome?

A Pressurized Spectra IV cable harness supplied with the back box is required to test and monitor the pressurized dome.

What are the instructions for installing the fiber optic module?

Open the hinged door to the back box by pushing the tab lock towards the wall of the unit and lifting the door open. Remove the plug from the 16-pin connector. Install the module in the 16-pin connector and secure it to the circuit board standoff using the provided screw and lock washer.