Pelco C3433M (3/07) Frame rate may not be attainable, Ips not available, Web browser, Available

Image quality	Image not focused	Adjust the field of view and the focus.
	15 ips quality bad	In some networks with high latency, the maximum
		frame rate may not be attainable.
	30 ips not available	The IP110 only supports MJPEG at rate up to 15 ips for
		NTSC camera modules where applicable. For PAL
		camera modules, the maximum rate is 12 ips only.
No dual streams	Web browser	Not available with Web browser. Only supported by
		Endura™ system or Pelco’s API Interface solution.
Cannot record an	Web browser	Not available with Web browser. Only supported by
MJPEG stream		Endura system or Pelco’s API Interface solution.
MPEG4 not	Web browser	Not available with Web browser. Only supported by
available		Endura system or Pelco’s API Interface solution.
Camera not	No camera power	Verify the camera is powered correctly with PoE or
discovered		with 24 VAC. Confirm power consumption with web
		interface of PoE-capable switch or through blinking
		green LED during camera power-up.
	Network conflict	Verify the camera is physically connected to the same
		network as the PC running the Device Utility.
Network not	Faulty cable connection	Check all cable connections and ensure all plugs are
working		properly plugged in.
	Incorrect serial device	A hub will not work with the available network
	configuration	bandwidth shared across all ports. Use a Fast Ethernet
		switch, Gigabit Ethernet switch, or a Cable-modem
		router with an n-Port switch.
	Network connectivity issues	Contact your network administrator.

20 C3433M (3/07)