Pelco CCC5100H , CONNECTIONS, VIDEO FORMAT OVERRIDE,

C2910M-B-QS (2/06) 5

CONNECTIONS

The CCC5100H Series camera offers standard power and coax video connectors.

To use the RJ45-10 multifunction connector that combines power, video, and control

leads, refer to

Multifunction Connector

in the Installation/Operation manual.

Connect 12 VDC or 24 VAC power to the two-pin power connector on the back of the

camera. Use a Class 2 isolated power source for the CCC5100H Series camera that can

supply 12-36 VDC ±10% or 24-28 VAC ±10%, 47-63 Hz.

Connect a video cable to the BNC connector on the back of the camera.

At power-up, the CCC5100H Series camera automatically selects the correct video

format. To manually override the video format selection

•

press and hold the top and center buttons to select NTSC, or

•

press and hold the center and bottom buttons to select PAL.

NOTE:

If using DC power in a PAL installation without Pelco V-Sync, use the two-

button override to select PAL. Otherwise, the camera will default to NTSC.