Installing main blade | Grizzly G0700 manual

11.Remove the shipping brace from the sliding table, then install the sliding table end cover over the fixed part of the sliding table end, as shown in Figure 17, using the premounted hardware. (Save the brace for future trans- port needs.)

Remove

Shipping Brace

Install End

Cover

Figure 17. Sliding table shipping brace and end

cover installed.

12.Attach the push handle assembly, as shown in Figure 18, with the two button head screws and flat washers already installed in the mounting holes.

Button Head

Cap Screws

Figure 18. Sliding table handle attached to end

of sliding table.

13.Thread (2) M5-.8 x 12 cap screws with 5mm lock washers through the switch bracket and into the sliding table base (see Figure 19), then tighten the cap screws.

Model G0700 (Mfg. since 8/09)

Magnetic

Switch

Figure 19. Magnetic switch installed.

14.Open the cabinet door and remove the motor shipping brace shown in Figure 20, then replace the fasteners where they were. (Save the brace for future transport needs.)

Figure 20. Motor shipping brace.

15.Tilt the blade assembly to 0˚, then move the sliding table out of the way so you can access the lower blade guard cover and blade arbors.

16.Insert the arbor lock tool into the hole shown in Figure 21, rotate the arbor until the arbor lock tool seats, then install the main blade per the instructions on Page 35 as a guide.

Grizzly G0700 owner manual Installing main blade

Models: G0700