3. Adjust the top of the extension table to be even with the cast iron table and snug the cap screws down enough to hold the table in place.
4. Using a straightedge as a guide (see Figure 11), adjust the set screws to align the top of extension table with the top of the main table. When the extension table is fully aligned and leveled with the main table, tighten the hex nuts on the set screws against the extension table to lock them in position.
Model G0700 (Mfg. since 8/09)
Thread (1) M8-1.25 hex nut halfway onto each of the (4) M8-1.25 x 25 set screws, then thread the set screws a couple of turns into the locations shown in Figure 10. These screws will help you level the table in the next step.
2.
Assembly & Setup
Before shipping, the sliding table was installed on the machine and calibrated to the main table and blade arbor.
The table and fence components are heavy so you must get help lifting and holding them during the installation process.
To assemble the sliding table saw:
1. Attach the extension table to the main table with (3) M10-1.5 x 25 cap screws, 10mm flat washers, and 10mm lock washers (see Figure 10). Do not fully tighten the cap screws at this time, because the extension table still needs to be leveled with the main table.
Cap Screws
Set Screws
Figure 10. Extension table installed.
Figure 11. Extension wing mounted and adjusted evenly with the cast iron table.
5. Mount the rip fence scale to the main table and extension table (see Figure 12) with (2) M6-1 x 16 hex bolts, (1) M6-1 x 25 hex bolt, and (3) M6-1 hex nuts, 6mm lock washers, and 6mm flat washers. Do not completely tighten the fasteners at this time, because the rip fence scale will need to be calibrated to the blade during a later step.
Note: The longer hex bolt is used in the cast iron table. Also, make sure the scale is even with both table tops before securing it in place.
| Table | ||
|
| Hex Nut | |
Scale | Hex Bolt | Flat Washer | |
Lock Washer | |||
| |||
|
| ||
