25. Make sure the fence is just touching the edge of the blade teeth, then adjust the position of the rip fence scale until the edge of the fence is aligned with the 0" mark on the scale. Once it is aligned, carefully tighten the rip fence scale fasteners.

26.Move the fence out of the way, and install the blade guard (Figure 25) per the instructions on Page 31. (This step is mandatory.)

Blade Guard

Figure 25. Blade guard installed.

27.Install the miter gauge as shown in Figure 26.

Miter Gauge

Figure 26. Miter gauge installed.

28.Install the hose support as shown in Figure 27.

Hose

 

 

Support

 

 

Lock Washer

Flat Washer

10mm

10mm

 

 

 

 

Large

Hex Nut

 

Extension

 

Table

M10-1.5

Hose

 

Support

 

 

 

Cap Screw

 

 

M10-1.5 x 25

Figure 27. Hose support installed.

DO NOT operate this saw without an ade- quate dust collection system. This saw cre- ates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and long-term respiratory illness.

Model G0700 (Mfg. since 8/09)

-25-

Page 27
Image 27
Grizzly G0700 owner manual Hose support installed