Grizzly G0700 owner manual Test Run, To test run the saw

Test Run

The purpose of the test run is to verify that the newly assembled machine runs properly and all safety devices are in proper working condition before any cutting operations are performed.

It is extremely important that all previous assem- bly and setup sections have been performed before performing this procedure. Also, it is MANDATORY that all steps in this section be followed very carefully and in the order given to ensure that the machine is correctly tested.

Before beginning the test run, review the power controls shown in Figures 33–34and the con- trols and components shown in Identification on Page 3.

ON Button

STOP Button

Figure 33. Main power switch.

Emergency

STOP Button

Figure 34. Emergency STOP button.

If the machine does not operate as stated in this section, review the troubleshooting section on Page 60. If you need additional help, call Tech Support at (570) 546-9663. DO NOT place a machine into regular opera- tion if you suspect that it is malfunctioning, or serious injury could occur.

To test run the saw:

1.Put on safety glasses, make sure any bystand- ers are out of the way, and that all tools have been removed from the saw.

2.Push in, then rotate the power switch STOP button clockwise until it pops out. Do the same thing on the emergency STOP button. This resets the switches so the saw can be started.

3.Press the ON button. The blades should start and run smoothly without any problems. If any problems occur, immediately press either STOP button, then troubleshoot and correct the before starting the saw again.

4.Make sure the power switch STOP button is pushed in all the way and the emergency STOP button is reset (popped out), then press the ON button.

—The saw should NOT start when either of the STOP buttons are pushed in. If this is true, repeat this test with the emergency STOP button pushed in and the power switch stop button reset.

—If the saw DOES start when either STOP button is pushed in, then it is not function- ing correctly. Call Tech Support for advice before proceeding any further with the test run or machine operations.

5.If you successfully completed Steps 1–4above, congratulations! The table saw is now ready for cutting operations.

-28- Model G0700 (Mfg. since 8/09)