Motion Settings
SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
MOTION
AUTO FLIP | ON |
PROPORTIONAL PAN | ON |
PARK TIME (MINUTES) | 0 |
PARK ACTION | NONE |
SCAN SPEED (DEG/S) | 25 |
LIMIT STOPS | ON |
<SET MANUAL STOPS> |
|
<CLEAR MANUAL STOPS> |
|
<SET SCAN STOPS> |
|
<CLEAR SCAN STOPS> |
|
<SET AZIMUTH ZERO> |
|
<CLEAR AZIMUTH ZERO> |
|
BACK |
|
EXIT |
|
REFERENCE INFORMATION |
|
MANUAL LIMITS SET | NO |
SCAN LIMITS SET | NO |
AUTO FLIP
When the camera tilts downward and goes just beyond the vertical position, the dome rotates 180 degrees. When the dome rotates (flips), the camera starts moving upward as long as you continue to hold the joystick in the down position. Once you let go of the joystick after the dome rotates, joystick control returns to normal operation. The
There are two auto flip modes:
ON (default) | Auto flip mode is enabled. |
OFF | Auto flip mode is disabled. |
PROPORTIONAL PAN
Proportional pan automatically reduces or increases the pan and tilt speeds in proportion to the amount of zoom. At telephoto zoom settings, the pan and tilt speeds will be slower for a given amount of joystick deflection than at wide zoom settings. This keeps the image from moving too fast on the monitor when there is a large amount of zoom.
There are two proportional pan modes:
ON (default) | Enables the proportional pan mode. |
OFF | Disables proportional pan mode. The pan speed will not depend |
| on the amount of zoom. |
*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.
22 |
|
