Pelco Manual C1471M (10/98) 154.6 PARK
If the dome does not receive any commands for a specified period, it goes to preset
1 and parks. The dome will not park if the time specified is zero or preset 1 has not
been programmed. The default is zero minutes.
4.7 PROGRAMMING THE SPECTRA® LITE
The dome can be programmed for the following functions:
AGC (automatic gain control) Gain Sharpness
Auto flip disable Limit stops Shutter speed
Auto park time Power line synchronization White balance
Backlight compensation Power-up mode
Camera reset Scan speed
The main menu contains four secondary menus: Camera, Line Sync, Power Up,
and Other. Each secondary menu has submenus, which are structured as shown
below. Beside the menu items are section numbers in parentheses showing where
the functions are explained.
1. Camera
First Camera Submenu Second Camera Submenu
Backlight comp (4.7.2) Shutter speed (4.7.5)
Reset camera (4.7.3) Sharpness (4.7.6)
Gain/AGC (4.7.4) Auto sharpness
AGC mode Sharpness
Gain White balance (4.7.7)
Next (to second camera Auto white bal
submenu) M-G white bal
Prev (to first camera submenu)
2. Line Sync (4.7.8) 3.Power Up (4.7.9)
Line sync Power up
Line sync phase
4. Other
Auto flip (4.7.10)
Limit stops (4.7.11)
Park time minutes (4.7.12)
Scan speed deg/s (4.7.13)
The following sections explain how to program the Spectra® Lite dome using the
menu choices.
4.7.1 Main Menu Access
You can call up the main menu on your monitor by programming (setting or creat-
ing) preset 95 (28). Programming preset 95 varies according to the type of control-
ler you are using. Below are instructions for programming preset 95 for various
controllers.
CM6700
1. Enter the number of the Spectra® Lite camera and press the CAM key.
2. Enter 95 and hold the PRESET key for two seconds.
3. In the Edit Preset menu, arrow to SET and press the ACK key. The main menu
appears.
CM8500
1. Enter the number of the Spectra® Lite camera and press the CAM key.
2. Highlight PRESET in the Camera menu and hold down the joystick button
until the Set Presets prompt appears.
3. Enter 95 and press the PRESET key. The main menu appears.