Pelco DF5S Series Description, Installation

4C1475M-B (8/05)

Description

The DF5S Series fixed mount dome is designed for indoor use where there is limited space above the ceiling. The dome can be installed in hard

ceilings or standard 2 x 2 ft (61 x 61 cm) suspended ceilings. The back box requires only 2.75 inches (7 cm) of room.

When there is not enough room to install the DF5S Series back box in the ceiling, the back box can be attached to the surface of the ceiling.

A special trim ring, the DF5S-SMKIT, hides the back box. The entire assembly (back box and dome) hangs down only 6 inches (15.24 cm) from the

ceiling.

DF5S-0* DF5S Series indoor dome with 2.75-inch (7 cm) back box and smoked lower dome (1/2 F-stop of light loss)

DF5S-1* Same as DF5S-0 except has clear lower dome (virtually no light loss)

DF5S-2* Same as DF5S-0 except has chrome lower dome (2 F-stops of light loss) and opaque dome liner

DF5S-3* Same as DF5S-0 except has gold lower dome (2 F-stops of light loss)

* The DF5S-SMKIT surface mount adapter kit is required to attach DF5S Series back box to the surface of a ceiling.

The DF5S shipping carton contains two boxes. Inspect each box to make sure all parts are present.

1 Back box with tilt table assembly installed (includes camera and lens if specified with order)

1 Parts bag

1 Conduit fitting with lock nut

1 Safety chain bracket

1 3-inch (7.6 cm) miniature coaxial cable assembly

1 Compass tool

1 Flat washer (models without camera)

1 Split lock washer (models without camera)

1 Screw (models without camera)

1 Acrylic lower dome with trim ring