Manuals / Pelco / Household Appliance / Home Security System

Pelco Dx8000 manual Disconnect the Data Cable and Power Wire

Models: Dx8000

1 32

Download 32 pages 20.54 Kb

Page 12

Disconnect the Data Cable and Power Wire

Disconnect the Data Cable and Power Wire

When removing the data cable and power wires, pull the connectors straight out. Do not rock connectors back and forth or remove a connector by pulling it by its wires or cable.

1.Remove the IDE data cable from the hard drive, CD-RW drive, and motherboard:

a.Carefully pull the plastic tab of each cable connector away from the hard drive and CD-RW drive. Refer to Figure 8.

b.Following the same procedure, remove the other end of each IDE cable from the drive interface connector on the motherboard. Refer to Figure 8.

HARD DRIVE 1a

IDE CONNECTOR

CD-RW

IDE CONNECTOR 1a

MOTHERBOARD 1b

IDE CONNECTOR

Figure 8. Removing IDE Data Cables

10	C1607M (6/04)

Image 12

Pelco Dx8000 manual Disconnect the Data Cable and Power Wire

Contents

DX8000 Hard Drive Upgrade Installation to a Two-DriveSystemsDX8000 Digital Video RecorderPage PARTS LIST IntroductionTOOLS NEEDED DescriptionGetting Ready Figure 2. Removing Power Cord from Unit C1607M 6/04Figure 3. ESD Protection Preparing Unit for Drive Installation OPEN THE UNIT CHASSISFigure 4. Removing Chassis Cover COMPONENT LAYOUT Move the Front Cross-Brace C1607M 6/04 Disconnect the Data Cable and Power Wire 2.Remove the power connector from the hard drive Figure 9. Removing Hard Drive Power ConnectionPOWER CONNECTOR HARD DRIVERemove the Drive Mount Baskets Install an Additional Drive PREPARE THE DRIVESMOUNT THE ADDITIONAL DRIVE 2.Mount the drive basket back into the chassis Figure 13. Replacing Drive BasketC1607M 6/04 SET THE MASTER / SLAVE JUMPERS Figure 15. Setting Drive Jumpers JUMPER MASTER SLAVE SETTING SETTINGCD-RW DRIVERECONNECT THE DATA AND POWER CABLES 1b 1a 1c2a 2b Figure 18. Installing Hard Drive Power Connectors C1607M 6/04Reassemble the Unit Figure 19. Replacing Front Cross-BraceFigure 20. Replacing Chassis Cover C1607M 6/04Figure 21. Restarting Unit Preparing the New Drives to Store Data Figure 22. Opening List of DrivesFigure 23. Opening Drive Options Menu d.Click Begin Allocation Figure 25. Initializing Drive Allocatione.The following warning appears. Click Yes Figure 26. Format Warning Dialog BoxFigure 27. PDB Database Creation Progress Bar C1607M 6/04 PRODUCT WARRANTY AND RETURN INFORMATION WARRANTYRETURNS Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & CanadaTel 800/289-9100 Fax 800/289-9150 International Tel 1-559/292-1981 Fax 1-559/348-1120